Užklausimas
Krepšelis
Krepšelis tuščias
Paieška

VILNIUS S. Žukausko g. 29, +37063769904
KAUNAS R. Kalantos g. 98, +37065387491
INTERNETINIAI UŽSAKYMAI +37065387491   info@rcdalys.lt

Akumuliatoriai, pakrovėjai > Akumuliatoriai > Li-Ion 18650 > BMS plokštės   Atgal

JK BMS 4S-8S 60A BT, RS485, CAN, HEAT JK-BD4A8S6P-HCR

Prekės kodas:

bd4a8s6p

Turime vietoje, pristatymas kurjeriu/paštomatu sekančią darbo dieną.

49.99

Kaunas: YRA
Vilnius: NĖRA, galimas atsiėmimas sekančią darbo dieną


Užsakymai pateikti iki 17h išsiunčiami tą pačią darbo dieną, dažniausiai pristatomi sekančią darbo dieną.
Prekės informacija
Gaminio savybės

JK-BD4A8S6P-HCR

Protection and balancing system for a battery consisting of 4-8 LIFEPO4, LTO, LI-ION cells

balance current 0.4A

complete communication interface, RS485, CAN including support for inverter and MODBUS protocols

it is possible to connect an interface board with RJ45 connectors (RS485,CAN, RS485_1, RS485_2) enabling communication with inverters and parallel BMS

includes BT and heating element control

mobile phone and PC applications available for download https://www.jkbms.com/support/

in the package:

BMS, button, wiring to the cells, cable to the heating element, M6 eyelets according to the number of cells, documentation

The condition for safe operation of a battery composed of LIFEPO4 cells is the use of a suitable BMS (battery management system) which serves for

Battery protection (disconnects the battery in case of undervoltage and overvoltage of any cell)
Battery status monitoring (voltage, charging and discharging currents)
Maximum utilization of battery capacity SOC
Estimating SOH battery status
Informing the user or powered device about the battery status
BMS connection example:

disconnect the connector from the BMS (cable to the battery cells)

connect B- BMS to the negative pole of the battery

connect the individual wires to the batteries

Measure the voltage on each pin of the connector. Measure against the minus (black wire)

you should measure for example: 3.2V,6.4V,9.6V etc...this will verify the correct connection

insert the connector into the BMS (B- must be connected to the negative pole of the battery)

Failure to follow this procedure may cause destruction of the BMS

when disconnecting the BMS, proceed in the opposite way. B- disconnect last


Parameters
number of cells in series: 4-8 pcs

charging current: 60 A

discharge current: 60 A

balance current: 0.4 A

bluetooth: Ano

intended for technology: LIFEPO4
Kita informacija