Remote ID

Overview
Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.

The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators.

If you need customization or have special request, feel free to reach out to us via email.

Specification
Radio module:
Espressif ESP-C3 module
Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
FCC & CE certified radio module
Firmware:
ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
Supports upgrading firmware via the web interface (OTA)
Supported in PX4 & Ardupilot (More Info)
Protocol: CAN & Serial
Interface:
1x JST GH 4-pin CAN (CAN) port
1x JST GH 6-pin TELEM (UART) port
Antenna Connector type:
On CNC Case: SMA connector
On PCB: IPEX Connector
Range: > 5km detection range*
Power: 5V supplied from TELEM or CAN port
LED lights: Bright RGB status LED
Size:
Without case: 35.3 x 23.5 mm (not including antenna)
With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)
Mount: M2 screws
Operating temperature: -40°C to +85°C
Weight:
PCB only: 4 g
With CNC case & Antenna: 27.5g
Without case & Antenna: 16.5g (Cable 20cm)
Certification: FCC& CE
* The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible.

Guides & Reference Link
Holybro Doc
Setup & Configuration Guide
Firmware Update Guide
Firmware support
Ardupilot
Ardupilot Wiki - RemoteID
Ardupilot Wiki - OpenDroneID FW building
PX4
PX4 Guide on Remote ID/OpenDroneID

Package Includes:
1x Remote ID
1x Antenna
1x JST GH 6pin 150mm Cable
1x JST GH 4pin 150mm Cable