MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If you're starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These V2 ESC's features BLHeli software for a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input.
All Multistar series ESC's come with bullet connectors installed that are suited to the ESC's rated power handling. This allows for plug and play convenience by simply adding the appropriate battery supply splitter (3,4 or 6 ESC) and motor lead extensions from the Multistar modular accessory line. What could be simpler?
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware ? The V2 Multistar comes with BLheli software pre-installed, and for those so inclined a ease to use USB tool is available for Configuration and updating via the BLHeli Suite GUI.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
Features
BLHeli Software
USB tool updating and configuration via BLHeli GUI softwareSmooth and linear throttle control
Slim design for easy frame installation
Fast response to throttle input
Atmel MCU
Stalled motor protection
Throttle signal lose protection
Safe power-on (throttle lockout)
Support 480Hz+ high refresh rates (up to 499hz)
Supports OneShot125
Spec
Constant Current: 20AInput Voltage: 2-6 cell Lipoly
BEC: Yes (linear) [Remove middle wire to disable]
BEC Output: 5V/3A
PWM: 8 KHz
Max RPM: 240,000rpm for 2 Pole Brushless Motor
PCB Size: 62mm x 13mm
Discharge Plugs: Male 3mm Bullet Connector
Motor Plugs: Female 3mm Bullet Connector
Weight: 20.3g