Užklausimas
Krepšelis
Krepšelis tuščias
Paieška

DĖMESIO!

RCDalys.lt Vilniaus Parduotuvė ATIDARYTA!

VILNIUS S. Žukausko g. 29, Šiaurės miestelis
KAUNAS R. Kalantos 98 Petrašiūnai
+37065387491
 info@rcdalys.lt

Vilnius  +370 637 69904

 

Dronai > Dalys ir komponentai > Kontroleriai ir priedai > Kontrolerių aksesuarai   Atgal

HKPilot Power Module with T-Connectors and 6 Pin 150mm Cable [121]

Prekės kodas:

9387000031-0

Turime vietoje, pristatymas kurjeriu/paštomatu sekančią darbo dieną.

20.00

/   32.67 € /
Kaunas: YRA
Vilnius: Galimas atsiėmimas sekančią darbo dieną


Užsakymai pateikti iki 17h išsiunčiami tą pačią darbo dieną, dažniausiai pristatomi sekančią darbo dieną.
Prekės informacija
Gaminio savybės

The HKPilot 2.5 Power Module incorporates both a way to power your HKPilot and accessories and report battery voltage and current to the HKPilot, this can be viewed in the HKPilot˙s stored logs or live with a telemetry radio. All through a single and tightly included 6-pin cable that directly matches the HKPilot˙s connector. The on-board switching regulator outputs 5.3V at a maximum of 2.25A, and can be used up to 18 Volts (4S LiPo) and at a maximum of 90 amps. The Power Module is ready to use with T-connectors pre-fitted, and shrink wrapped for protection.


Note: The Power Module is rated at 2.25 Amps to power the HKPilot, receiver and peripherals (GPS and Telemetry radio) ONLY. To power servos use an ESC with an adequate BEC or a standalone BEC plugged into the output bus, and remove jumper 1 to isolate the two power lines.


Spec


Max input voltage: 18V

Max current sensing: 90A

Switching regulator outputs: 5.3V at 2.25A max

6-pos Molex cable plugs directly to HKPilot

Voltage and current measurement configured for 5V ADC


Includes


DF13 6 Position Connector 150mm long

HKPilot Power Module with T-Connectors
Kita informacija