Propeleris.lt sandėlis Atgal

V1.2 Mechanical End stop for 3D Printer, Reprap, Prusa, Mend...

V1.2 Mechanical End stop for 3D Printer, Reprap, Prusa, Mendel, Makerbot [145]

Prekės kodas:

3DPR0004

Turime vietoje, pristatymas kurjeriu/paštomatu sekančią darbo dieną.

8.41 €

Kaunas: YRA
Vilnius: NĖRA, galimas atsiėmimas sekančią darbo dieną

Užsakymai pateikti iki 17h išsiunčiami tą pačią darbo dieną, dažniausiai pristatomi sekančią darbo dieną.

Prekės informacija

Gaminio savybės

These mechanical end stops are quiet simply a means to an end. They detect when an x/y/z stage has reached its minimum or maximum. Excellent if you do not want to get bogged down in complicated light beam interrupters or flags. The screen print on the board states that instructions are located at a specific web address (as does the schematic available on our forum), however this is not the case. If you have any problems, please contact us for advice.

Supplied with a 50cm cable allowing you to connect the endstop directly to the header pins of your controller board without the need for awkward soldering.

Kita informacija