Hobbywing XRotor 10A controller for multicopters up to 250mm, continuous current 10A, peak 15A, without BEC, power 2-3S, weight 7g, dimensions 44.2 x 12.2 x 9.2mm, OneShot mode, 2mm GOLD connectors cables.
Hobbywing controller specially designed for multicopters. Ideal for 250mm. Continuous current 10A, peak 15A. It does not include an integrated BEC. Power supply 2-3S. Weight 7g. Dimensions 44,2x12,2x9,2mm. OneShot mode supported. The Wire Leaded version has connectors, for motor connection, on power cables (2mm GOLD).
Very fast gas response
Special FW for multicopters ensures very fast gas response.
Easy to use
Everything except timing is pre-set by the manufacturer, making the controller very easy and quick to use.
Huge compatibility
Special software, adapted directly for this controller, allows great compatibility between the motor and the controller.
Twisted signal cable
The twisted signal gas cable provides less interference when transmitting signals between the controller and the controller.
Super low internal resistance
Thanks to high-quality MOSFETs, a very low internal resistance is possible, but also a high current carrying capacity.
Super high gas signal
Compatible with a wide range of controllers and supporting gas signal up to 621Hz.
Use Multikopter
Type alternate
Continuous current [A] 10
Max. peak current [A] 15
LiXX Articles 2 - 3
Length [mm] 36.5
Width [mm] 16.4
Height [mm] 4.1
Weight [g] 6.5
Regulation one-way
Programmable Year