Eagle Tree Systems Micro Vector Flight Controller w/OSD

Features:
• Simple setup and configuration
• Full color OSD graphics
• Multi-RF protocol
• 5 RSSI types
• Precise, low latency DMA enhanced control loop (<8 kHz)
• Support for present and future Oneshot ESC protocols
• Standard 30.5mm mounting hole centers
• Suitable for multi-rotor and fixed wing
• On board altimeter for altitude hold
• Full telemetry
• GPS capable GPS module required)
• Supports SkyGates virtual racing (GPS module required)
• Updateable
• Compatible with existing Vector GPS V2 and current sensor/PSU modules and wiring harnesses
• Programmable video power control
• Fast 32-bit microcontroller

Compatibility:
• Standard 30.5mm mounting hole centers
• PWM, SPPM, Spektrum Satellite and S-BUS Receivers supported, with 4 types of RSSI
• BLHeli ESC configuration via USB port
• Compatible with most PDBs, including those with built in current sensors
• Multirotor airframes: Racing drone, Quad/Tri/Hexacopter or Y6
• Fixed wing airframes: Traditional, elevon, V-tail

Software compatibility:
• The software is compatible with Windows™ 10, Windows™ 8/8.1, Windows™ 7, Windows™ Vista™, and Windows™ XP™. Most Windows based PCs, laptops, notebooks, and tablets (including the Surface™ Pro™) are compatible with the software.


Specs:
Type: Eagle Tree Systems Micro Vector Flight Controller w/OSD
Processor: 32 bit
Output: 5V & 12V 1A DC (500mA max on the 5V output if the alert buzzer/LCD is used.)
Servo/ESC frame rate: Multirotor - <8kHz with MultiShot capable ESCs/Fixed wing - adjustable <400Hz
Video format: NTSC/PAL composite (auto detect)
Mounting holes: 30.5 x 30.5mm
Dimensions: 38 x 38 x 10mm (w/case) 36 x 36 x 7mm (w/out case)
Weight: 13g (w/case) 7g (w/out case)

Included:
Eagle Tree Systems Micro Vector Flight Controller w/OSD in case
Set of 5 pigtail cables for precise installation

Please note: Micro Vector is not recommended for large or heavy airframes, due to no or limited testing on these types of models at this time. Examples: giant scale fixed wing models, turbines, or multirotors larger than 650mm are not recommended.